View Single Post
Old 11th August 2012, 05:52 PM
Scooby's Avatar
Scooby Scooby is offline
Pete Dutton
Join Date: Nov 2008
Location: Rotherham
Posts: 2,647

If you measure the amount of bolt shaft visible between the action block & the bolt then just use an oring slightly bigger than this gap. What will then happen is the oring will be compressed slightly as you close the bolt which will put back pressure on the bolts cocking pin, it wont then flip open.

You don't need to strip anything you just slide the O'ring over the bulb of the bolt then push it up & over onto the shaft, if the O'ring it not the correct size then cut it off & try another

Last edited by Scooby; 11th August 2012 at 05:56 PM.
Reply With Quote