Thread: airarms ev2 mk4
View Single Post
Old 8th May 2012, 09:10 AM
Willbe's Avatar
Willbe Willbe is offline
I Like BIG Hats!
Join Date: Dec 2008
Member of: Far Coley FTC
Location: Cheadle, Staffs
Posts: 862

Originally Posted by Steve Bowers View Post
I had an EV for a while and found the same problem (they should have stuck to the two post's)
I made a thin rubber washer just smaller than the ball and fitted it into the ball cup.
You will also have to get a longer screw to make sure you use all the thread in the hole.
It's also a good idear to change all the 6mm screws fitted as standard from "button head to socket head".
And plated screws are better than the stainless ones fitted.

Hope this helps

The stainless on there is likely to be A2 grade (304) which can be soft, upgrade to A4 grade (316) which is harder (more chrome in it)
AirArms RN10/EV2 Stock-2007 Big nikko FT Kit
AirArms NJR100 Hawke Airmax SR6 HFT/SFT Kit
Feinwerkbau 600 10 metre
HW77K-zeiler 6-24x44 Work in progress
Webley Vulcan .22 Lovely old relic
Reply With Quote