I got an Air Arms 200 from " jackson grainge " which iis a great little gun !
My main reason for this was so my grandson " age 8 " could shoot a gun that wasn't as big as him.
But I found that with a silencer fitted it was a great little gun for shooting in the garden.
Only thing that let it down was the wood work, a bit plain !!
My first thought was to get a wood blank and give the little gun a face lift but as I had a Ginb stock " to fit a HW100 " that no one wanted to buy " check out my old add " I thought with very little work it could be made to fit in it.
So far it's looking good !!
Now to the main reason for this thread .....
Can I fit a pressure gauge to an air arms 200 ?
If I could get an adaptor to fit between the action and the air cylinder I could than drill and tap 1/8 bsp into it from the under side and fit a small gauge there.
Any one out there have any idea's