View Single Post
Old 3rd January 2012, 10:20 PM
AirArmsDavid AirArmsDavid is offline
Senior Member
Join Date: Apr 2009
Member of: Kibworth
Location: Near Lutterworth, Leics
Posts: 233

Originally Posted by CameronWilson View Post
Good stuff.

Remember to replace the split O-ring on the set screw shaft before you reinsert it into the Stabilizer body, otherwise the two will separate and you'll need to strip the rifle again.

I've done that before.
Yes, I found the split O-ring remained in the spring tube after a couple of removals. It was sideways on so I had to make a tool to poke in and remove it (wire with bent end). Once screw adjusted the O-ring is placed onto it before reinserting. And repeat!

I've just emailed Ernst Huber, Chief Technical Officer at Steyr to ask about the different stabiliser setting for 6 and 12 ft lb models and whether firing a pellet should give the same end position as the adjustment process.

Will let you know what he says.

Reply With Quote