View Single Post
Old 28th December 2011, 06:36 PM
CharlieFarlie's Avatar
CharlieFarlie CharlieFarlie is offline
Senior Member
Join Date: Dec 2011
Member of: Member of Worcester Air Rifles and Glenrothes Target shooting club.
Location: The vale of Evesham..
Posts: 212
Default Bi Pod stud fitment

The Bipod/sling stud on My R10 came out today.. The stud is obviously not thick enough to grip the hole in the stock... So do the studs vary in the thickness of the threaded part ??
I'm hoping I can put in a thicker threaded one instead of resorting to using glue or silicone to hold the old one in place..

The old one does still thread and grips a little but obviously not enough to hold the guns weight . I had it over My shoulder on a leather sling when it pulled out. Fortunately I caught the rifle.....

So Guys whats the advice ? Use some glue or clear silicone or is there an option of a thicker stud ...

If its to be stuck then what would or have any of You used successfully ?...


Reply With Quote
Connect With Facebook to "Like" This Thread