Thread: airarms ev2 mk4
View Single Post
Old 11th December 2011, 05:44 AM
Steve Bowers's Avatar
Steve Bowers Steve Bowers is offline
Senior Member
Join Date: Feb 2011
Member of: Pontefract
Location: Leeds
Posts: 271
Thumbs up Airarms ball's

I had an EV for a while and found the same problem (they should have stuck to the two post's)
I made a thin rubber washer just smaller than the ball and fitted it into the ball cup.
You will also have to get a longer screw to make sure you use all the thread in the hole.
It's also a good idear to change all the 6mm screws fitted as standard from "button head to socket head".
And plated screws are better than the stainless ones fitted.

Hope this helps

Reply With Quote