View Single Post
Old 6th January 2011, 08:05 PM
maestro's Avatar
maestro maestro is offline
Senior Member
Join Date: Nov 2009
Member of: Harriers
Location: Sutton-in-Ashfield, Notts
Posts: 613

I think, Will, this is partly only playing with the words. My solution works and acts like a free floated barrel and this is what I wanted to. And I know very sure that two close supports are the same as one long fixed support, viewed from even only 1 mm further... So if you say that my pic nr1 is a free floated barrel then why isn't it my pic nr2? You can build both and you'll find practically no difference in their working method. Or I go any further: if you take the original breech block support which is about 3 cm long. If you saw into the middle so it will be two 1.5 cm wide supports beneath each other, what will happen? Or with a wider saw so 1 cm support, 1 cm hole and one cm support again? This will stay the same type of support for the barrel if you look at it from outside.

But I can then make my meaning more exact: the point is that the barrel is free floated after the scope is mounted on it.
The Updated BFTA Manuals Maestro Design FT Accessories
Reply With Quote