View Single Post
Old 20th May 2009, 06:42 PM
steve RS's Avatar
steve RS steve RS is offline
New Member
Join Date: Apr 2009
Posts: 8

Practise on someone else's stock !

Have you a scrap bit of wood ?

Drill your 3/4mm hole first, a good tip is measure on the drill bit the depth you want to go to and wrap some tape around just above.....

Then you can countersink the hole, make sure all bits are sharp !


Edited to say:

The tip above (clamping between two scrap bits) is a top tip !
Reply With Quote