Thread: stock fitting
View Single Post
Old 21st July 2010, 11:36 PM
rick's Avatar
rick rick is offline
Senior Member
Join Date: Dec 2009
Location: Barnsley
Posts: 240

Originally Posted by Willbe View Post
How you get on with the pressure gauge? much routing or removed the gauge?
I drilled an 25mm hole in the right place for the gauge and took a bit off the side of the stock for the level. Mine is a mark 1 EV2 so I had to drill a couple of hole for the hamster legs and one for the bolt that clamps the hampster.
Redfearn FTC
Reply With Quote