Originally Posted by Akita
I set it so the transfer port is fully open i.e the screw is flush on the inside of the transfer port so no restriction.
I then set the hammer to about 770fps this has always given good consistency and shot count around 80 shots.
Simon whats the benifits of restricting the transfer port on a regged S200?
You will find if you set it to 800 on the hammer with a wide open port and then trim it to 785 ish on the screw it will tighten the consistency a little with no loss of shot count.
HFT, for people with only 2 buttucks!
VooDoo TwoTwo The next chapter.