View Single Post
Old 12th September 2016, 12:19 PM
Marmitinator Marmitinator is offline
Senior Member
Join Date: Jan 2010
Member of: Purley Chase ftc
Location: stourport
Posts: 2,342
Default Turret adjustment

1. Seems there are gripes about the Torx screws and resetting the zero. Has to be done just right or the turret spins but doesn't click or vice versa. Any tips for adjusting and setting the turrets properly? Some people apparently remove some kind of spring too??

Same problem with Casey.After zeroing the scope I removed elevation turret for re-set but I didn't mount again.Any tips,advice?


You need to zero the scope at your preferred range , then grip the turret why you undo the torx screw a little. The turret will rise on the spring and you should be able to rotate until it is on the "0" then press it down and do up the torx bit.
They are a bit fiddly to be fair.
Under the turret is a large wayvey Spring that some choose to remove but it not essential .
About as much use at field target , as a life guard at the Olympic swimming pool.
Reply With Quote