View Single Post
Old 18th July 2016, 08:23 PM
vinny's Avatar
vinny vinny is offline
WHFTA 2015 World Champion
Join Date: Mar 2014
Member of: M.A.D
Location: essex
Posts: 578

Originally Posted by tillygti6 View Post
I can't say for sure on your particular one , but this stock , the trigger cutout wasn't central with the cylinder inlet. As you pulled the bolt up it pulled it in ****** .
If anything I'd not want your trigger block touching the front or rear face of its cutout
But whatever is suggested some guns just dont get on well with some actions.
Some prefer a rock solid inlet some dont. It's much like pellet batches!.
Hmm funny enough mine contacts in this area too , thats a starting point then .
I can appreciate where your coming from on some comments , would you consider alleviating an area between action and stock for the most part but still maintaining solid contact mounting points, the original stock really only contacts fore and aft on these locations

FTP900 MTC connect,Welhamanium internals -sorted
HFT500, ACZ stock MTC connect
TX200 Mk3 CS1000 stock, hawke vantage sf , Nick G internals
Steyr ?, maybe , they cant all be wrong?
Reply With Quote