View Single Post
Old 23rd April 2016, 06:37 AM
skires skires is offline
Senior Member
Join Date: Apr 2009
Posts: 950

This is common practice isn't it?

You clamped tight the rear mount but put a smear of flexi drying sealant around the scope at the front mount. Then just pinched up the mounts at the front point onto the sealant. So when the sealant dried the scope was supported but could move slightly in the flexi sealant at the front mount.

Who does this?

Last edited by skires; 23rd April 2016 at 07:30 AM.
Reply With Quote