View Single Post
Old 16th October 2015, 05:49 PM
Marmitinator Marmitinator is offline
Senior Member
Join Date: Jan 2010
Member of: Purley Chase ftc
Location: stourport
Posts: 2,342
Default Barrel machining

I've not seen an Ftp barrels machining but the Ev was only about an inch with the transfer port drilled in the bottom . From memory mine was 40 thou out over that inch which resulted in the barrel being at least 3mm out at the muzzle . If you clamp that to an air cylinder it equals shift.
About as much use at field target , as a life guard at the Olympic swimming pool.
Reply With Quote