View Single Post
Old 16th October 2015, 04:30 PM
Marmitinator Marmitinator is offline
Senior Member
Join Date: Jan 2010
Member of: Purley Chase ftc
Location: stourport
Posts: 2,342
Default Barrel machining

I had an Ev that when you looked down the action you could see the barrel did not line up with the air tube. When the barrel was put in a lathe and the machining clocked it was a mile out, well several thou of an inch.
May be that's why the barrel is pointing up , I had the barrel machining re sleeved and it was perfect afterwards.
About as much use at field target , as a life guard at the Olympic swimming pool.
Reply With Quote