Thread: Hft500
View Single Post
Old 12th October 2015, 09:36 AM
Waldo Waldo is offline
Senior Member
Join Date: Nov 2011
Member of: B O A C, B R P C ,
Location: Bolton
Posts: 356

I was going to fit a reg in mine, but after removing all the grease from the hammer, hammer spring the spring edges were very rough and not finished off !, spring guide and polishing, I get with pellets straight from the tin , under 3fps variation over its sweet spot , and 5 fps ish over the fill. I fill to 180bar and shoot down to 110 bar. The only thing I put Moly on was a tiny amount on the cocking lever slot after smoothing the edges . hth Gordon.
Reply With Quote