View Single Post
Old 18th August 2015, 12:16 PM
C.Eaton's Avatar
C.Eaton C.Eaton is offline
Senior Member
Join Date: Aug 2011
Member of: ETL / TEGC
Location: Hockley, UK
Posts: 431

As Vinny says the 'rivet' is in fact a simple pin which you can push out with the end of an allen key.

There is also an allen bolt each end of the aluminium channel, just remove the channel, refit the screws and pins each end and keep somewhere safe.

Regarding the shim between the bottom of he action and the stock, I took this out, gently sanded to remove any high spots on the quite rough stock then replaced with a few dabs of gorilla glue to keep perfectly centred on the stock screw holes.
Reply With Quote