View Single Post
Old 14th August 2015, 06:52 PM
Waldo Waldo is offline
Senior Member
Join Date: Nov 2011
Member of: B O A C, B R P C ,
Location: Bolton
Posts: 356
Default Uk Neil HFT500 transfer port" o" ring mod in place

Pictures of UkNeil`s modification in place before re-assembling the rifle. I have cleaned and de-greased the hammer, spring guide, pellet probe, the ident o ring on the pellet probe had split so the cocking lever didn`t snap back into place. After the de-grease I spent some time polishing the hammer etc to a mirror finish . Also polished the trigger sears , the trigger originally had a lot of side play on the trigger bar so when it was originally serviced (SCR) The collar for the trigger post was ground off and a fine brass shim fitted on the pivot post and this virtually removed the play from the trigger. Many thanks to Woki and Julian Bond for the help and advice. Regards Gordon.

Last edited by Waldo; 14th August 2015 at 07:03 PM.
Reply With Quote
Connect With Facebook to "Like" This Thread