View Single Post
Old 24th June 2015, 12:49 PM
Adam Adam is offline
Senior Member
Join Date: Jan 2009
Member of: Redfearns & the UBC
Location: Leeds
Posts: 583

I've never done anything about it but spoken to a gunsmith/machinist about it.
Some sort of collar that expands as you tighten a nut might work to locate a threaded adaptor might work as a non-permanent solution, but I don't know how secure that would be.

Alternatively drill out the frame where the barrel slots through and machine a new barrel end holder (extra fixings might be necessary to hold this in place, or you might bond it in. This new barrel holder could have a male 1/2" UNF thread protruding, then you're good to use any standard screw on moderator.
Reply With Quote