View Single Post
Old 21st June 2015, 04:41 PM
Martz's Avatar
Martz Martz is offline
Senior Member
Join Date: Apr 2009
Member of: Redfearn FTC
Location: Sheffield
Posts: 238

Originally Posted by RobF View Post
I think so. I haven't got it here at 'work' (sssh, i'm rendering ok...)... but when we looked any movement in the level was translated into the compression. There appeared to be no slack.
Hi Rob, after dropping the underlever out of the catch, I can draw the underlever down around 8mm more before any movement is translated to the compression cylinder. So there's a good bit of wiggle.

I wonder if a new cocking arm would solve it?

Reply With Quote