View Single Post
Old 18th October 2014, 09:08 PM
Sundance's Avatar
Sundance Sundance is offline
Senior Member
Join Date: Mar 2013
Location: swansea
Posts: 257
Default springer zero shift

Would appreciate some advice please.

Been having zero shift on my Walther LGU with Falcon T35. Scope is on a Sportsmatch dampa mount on a one piece BLK riser block.

Noticed that riser block screws often needed a quarter turn to re tighten so I`ve taken it off. I hope that will cure it. Rifle back to shooting well today ....(but at the expense of the flatter trajectory).

However, the one piece mount has no recoil pin.

My question is this...

Should I use some thread lock on the locking bolts ?

Perhaps some thread lock or other substance on the rifle rail and scope joint?

Some thread lock on the other screws that hold the scope?

Reply With Quote
Connect With Facebook to "Like" This Thread