View Single Post
Old 9th June 2014, 11:07 AM
hmangphilly hmangphilly is offline
Senior Member
Join Date: Nov 2013
Location: wimborne
Posts: 569

Originally Posted by Arthur View Post
ugh - found the answer by re reading again the link maestro sent.

But even with this info - if the windage is out by 25mm at 13m is that beyond acceptable? Just asking before I put these mounts in my milling machine (and then go out and buy some new expensive mounts after I've ruined these ones).
try shimming the mounts as per maestro.
its fine
Reply With Quote