Thread: EV2 help please
View Single Post
Old 25th May 2014, 08:31 PM
Yorkshiretea's Avatar
Yorkshiretea Yorkshiretea is offline
B Grade Bandit
Join Date: Aug 2013
Member of: Anston FTC
Location: Sheffield
Posts: 2,165

Originally Posted by Shaun View Post
Barrel - visibly seem ok. Should I remove it and roll on a flat surface?
You could visibly see one bends on mine but the one in the middle was only visible on a flat surface. It could be worth checking and is easy to do and may put your mind at rest. Not sure what's going on with your reg either to give you that much spread Shaun, that's a big spread and I would be worried about that as well.

The problem you described was exactly what my EV2 was doing tho, 2 on top of each other and then one an inch wide but always on the same side unlike yours, which sounds like it could be the scope.

Hope that helps some and good luck.

Last edited by Yorkshiretea; 25th May 2014 at 08:33 PM.
Reply With Quote