View Single Post
Old 8th March 2014, 07:23 AM
Brian.Samson's Avatar
Brian.Samson Brian.Samson is offline
Allowed in Sales
Join Date: Jun 2009
Member of: Pontefract, Doncaster Airgun Range
Location: Doncaster
Posts: 2,330
Default Making a scope enhancer

Seems like there's a real shortage of scope enhancers these days.

I wonder if it would be possible to make one using 'Sugru' and a 3D printed mold?
Hmm.. I might have a look at some test molds and see if it'll work.

With the size of a scope enhancer printing a full mold is likely to be very expensive - probably looking at about 150 for a mold, but once it's made it can be used over and over again.

Not sure how strong and durable 'Sugru' would be, and it's quite expensive too.

Anyone had any experience with Sugru or any suggestions?

I found this link to a project where someone made a small item using this method.
Reply With Quote
Connect With Facebook to "Like" This Thread