View Single Post
Old 31st December 2013, 02:16 PM
Brian.Samson's Avatar
Brian.Samson Brian.Samson is offline
Allowed in Sales
Join Date: Jun 2009
Member of: Pontefract, Doncaster Airgun Range
Location: Doncaster
Posts: 2,324
Default 3D Printed '****** Tail' Butt Hook

The design I've been working on is just about done now and ready to be sent off to the printers.
I think they've shut down for the holiday's but I've costed the print at around 100. The hook part is by far the most expensive coming in at nearly 40 for that one bit alone, so it may work out more economical and stronger to have a more simple hook made from aluminium.

Anyhoo, here are some renderings.. one as it might look in polished aluminium and a few as it would look if it was made from LEGO

Edit: I'm not allowed to say BEAVER on here apparently
Attached Images
File Type: jpg 20131231-untitled.31.jpg (166.3 KB, 705 views)
File Type: jpg 20131231-untitled.33.jpg (120.4 KB, 653 views)
File Type: jpg 20131231-untitled.34.jpg (105.4 KB, 474 views)
File Type: jpg 20131231-untitled.35.jpg (95.9 KB, 410 views)

Last edited by Brian.Samson; 31st December 2013 at 02:18 PM.
Reply With Quote
Connect With Facebook to "Like" This Thread