Thread: rn 10 protarget
View Single Post
Old 29th December 2013, 04:40 PM
Adz Adz is offline
Banned from Sales
Join Date: May 2011
Location: Herts
Posts: 31

pro target regs need to be serviced by somebody that knows what there doing, for a start getting the reg apart should ideally be done in a lathe chuck as to not damage the surface. reg tester is needed to set around 105bar and washers need to go in correct order with just the right ammount of grease on them. Take it to someone that knows what there doing, get it fully serviced and it'll be good for 2 years
Reply With Quote