View Single Post
Old 28th December 2013, 02:03 PM
Tone Tone is offline
Senior Member
Join Date: Apr 2010
Member of: Glevum & Quarry Hunters
Location: Bristol
Posts: 625
Default ft/s change on sized pellets

I have recently gone through a phase of sizing pellets, that was until I found a reduction of over 20 ft/s (over .5 ft/lb) between with the sized pellets compared with those strait out of the tin.

I can only put this down to the sized pellet skirt not blowing out against the barrel wall the same as the unsized one and therefore not creating such a good seal.

Has anyone else found the same thing happening?

Reply With Quote
Connect With Facebook to "Like" This Thread