Thread: Falcon T 50
View Single Post
Old 13th December 2013, 08:40 AM
hmangphilly hmangphilly is offline
Senior Member
Join Date: Nov 2013
Location: wimborne
Posts: 584

Originally Posted by rich View Post
Stuart, I'm fortunate in that I have CorelDraw on my machine, a vector graphics package that I use quite a lot for DTP and publishing. So I use that to make a printable file.

How do I set the marks? Well, I wrap the sidewheel in masking tape, mark the tape with the ranges as found by experiment, then lift the tape off the wheel, stick it to a flat sheet and run it under the scanner. Next job is to create the image as a vector file just by tracing over the marks of the scanned image.

Then print, and stick onto the wheel. The original masking tape strip goes into the dustbin.
oooh rich
I reckons you're about to get a load of bits of masking tape in the post
Reply With Quote