Originally Posted by Lol Moore
I knew it, nothing is new
But surely if you can see light through the rifling then you ream down below the depth of the rifling the diameter where the pellet sits is now bigger than the pellet so air escapes around the top?
Now if you did this taper reaming and also flared the skirt of the pellt so it was a snug fit in that taper that would be da'boss
You will find that when the minimum amount is reamed out to remove the rifling the smooth bore of the barrel is still smaller than the dia of the pellet skirt so pellets straight from the tin will from a very good seal.
I do weigh pellets to eliminate the extreme low and high weights, maybe this just gives me more confidense than anything else but it cant hurt.
HFT, for people with only 2 buttucks!
VooDoo TwoTwo The next chapter.