View Single Post
Old 25th August 2013, 02:53 PM
JerryD's Avatar
JerryD JerryD is offline
Senior Member
Join Date: May 2009
Member of: Hereward FT&ARC
Location: Rutland (it's titchy!)
Posts: 259
Default GC2: Inlet valve type?

Hi All;

Think I've traced down why my GC2 is pismehaving: filled it yesterday only to find the inlet hissing back at me like a snake!

Can anyone tell me what type of fitting is used on the GC2 inlet valve ( it's a MkII)? Also, is it the qiuck coupling fitting itself that provides the seal like the early Air Arms S400, or is there another seal inside the end block that comes off with the shroud after removing the 3 caphead screws at the barrel end of the cylinder?

In short, is this a DIY fix or an away to Mr. Brayford?

Hereward FT&ARC
Reply With Quote
Connect With Facebook to "Like" This Thread