I recently had a gun that was throwing a few stray shots, i pulled it through untill the patches where clean, it still did it, i pulled the reg out and serviced it, it still did it, i stripped the whole gun cleaned the hammer cleaned the barrel again checked the reg again, everything was good but it still did it. I then put a few drops of an electrical cleaning solvent in the barrel and gave it a scrub with a nylon brush, the muck that came out was unreal!! i then pulled it through untill it was clean and it was back on song again. It would appear that the pull through even though i do it very! tight untill the patches are clean was not getting everything out of the rifling. it is worth a try before you send it away for a service it may not need.
HFT, for people with only 2 buttucks!
VooDoo TwoTwo The next chapter.