View Single Post
Old 18th August 2013, 08:00 PM
paula's Avatar
paula paula is offline
Senior Member
Join Date: Sep 2009
Location: newport
Posts: 381

the butt pad is made of two parts the harder plastic is screwed on the the stock with 2 screws then the rubber part is glued on to it, if your not to worried about keeping the original pad. if you feel the rear of the pad you'll find 2 soft parts about 20mm from the top and bottom of the rear surface of the pad on the central line. You can push a possi drive screwdriver through the rubber and unscrew the whole thing from the stock.
hope this helps
Reply With Quote