View Single Post
Old 27th May 2013, 07:05 PM
paul4be paul4be is offline
Why do I bother????????
Join Date: Feb 2011
Member of: Darlington RA
Location: Richmond, North Yorkshire
Posts: 1,201
Default Air Arms cylinder strip down

I am looking at renewing the cylinder on one of my pro targets.
I am going to fit a new front end plug as well due to some edge damage to the current one. Due to cost, I would like to re-use the rear end plug assembly if possible.
Is there a trick to getting them out without marking the alloy surface?

Just don't want to find out that it won't move and I should have just ordered new anyway (although it's not cheap!!). I have grip straps etc.

Reply With Quote
Connect With Facebook to "Like" This Thread