View Single Post
Old 9th May 2013, 09:31 PM
ellis d's Avatar
ellis d ellis d is offline
Senior Member
Join Date: Jan 2012
Member of: Castle ftc
Location: Leicester
Posts: 906

Originally Posted by Ratinator View Post
I'm looking to replace the pin that pull's the hammer back when cocking,can any tech guy's tell me if a roll pin of the correct diameter will be ok for this application.
thanks simon
A rusty nail would do the job.... more than good enough for you simon
EV2mk4-Nikko nato mk1
Pro-Target-Nikko nato mk3
TX200mk3-Bushnell elite.
Reply With Quote