View Single Post
Old 20th March 2013, 05:14 PM
SDplinker's Avatar
SDplinker SDplinker is offline
Pellet testing...yawn
Join Date: Apr 2011
Member of: CASA - California Airgun Shooters Association
Location: Atascadero, CA, USA
Posts: 363
Default RN10/Pro-Target transfer port

I've only looked at one of these up close... it appears that the transfer port is actually drilled through the barrel and comes out right under the breech? Then the breech block closes against the face of the barrel and transfer port to seal it.

Is this correct in how it works and if a new barrel was to be machined for the RN10 it would have to be ported this way?
Reply With Quote
Connect With Facebook to "Like" This Thread