View Single Post
Old 19th December 2012, 01:41 PM
Adam Adam is offline
Senior Member
Join Date: Jan 2009
Member of: Redfearns & the UBC
Location: Leeds
Posts: 584

Originally Posted by fatwelshboy View Post
The HW100 can have a lot of thick grease on the hammer/shuttle. I cleaned this grease away on mine and used Dri-Slide instead. It would still shift a little with the cold but nothing like it did with the standard grease. Something like this thread on the WOC
^^^ This

Before I degreased, my HW100 would shift from 10 ft.lbs at zero degrees to near limit on a hot day.
I chronoed it in the cold, then at home when the action had warmed up every 3 degrees I chronoed it again.

Then I stuck a temp strip to the action and actually made up a table with a different set of clicks for every 3 degree band!
Reply With Quote